铁路站场与信号工程设计接口研究

Abstract
Figure/Table
References (0)
Related Citation (15)

Download: PDF (548 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract Abstract：Research purposes： By using systemic analysis method,this paper, focuses on the technical issues between track-layout and signal system, such as system matching design, station effective length of track & platform settings, catch siding, successive route, turnouts in receiving-departure track, and turnout-settings in station etc. The contents and conclusions, which researched, are of positive significance not only in the quality improvement of railway track-layout and signal interface design, but also in the enhancement of the systemic railway engineering design.
Research conclusions：(1) The turnouts on which CTCS-0 is employed should not be the one with turnout number greater than 18#. The turnouts where CTCS-2 control system is adopted should not be the one with turnout number lower than 9#. (2) In case the distance between track center line and edge of platform is 1 750 mm, the speed limit of the main line should be set below 80 km/h, and correspondingly, the design of the turnouts and the tracks within station should be in line with the speed limit of train control system.(3)The effective length of passenger station track, the position and length of platform, and the locomotive stop location mark should take reasonably consideration into the starting signal, fouling post, balise and so on, which should be in line with the technical requirements of train control system. When it is difficult to meet the normal technical requirements in terms of the platform length and effective length of passenger station track due to the geographic and geomorphic conditions, special signal solution should be considered. (4) The position of catch siding should not be far from the intersection of the two lines extra safety methods such as "red light" or other train control measures combining with necessary traction simulation should be adopted to satisfy the requirements of safety and efficiency.(5) A conversion slope outside the home signal within the braking distance should not be greater than 6 per thousand as far as possible. If the conversion slope is greater than 6 per thousand, measures should be taken to satisfy the requirements of interval time design.(6)The turnouts layout for railway stations with more than two main lines should satisfy the installation requirements of movable switch machine.(7) The turnouts arrangement in CTCS-2/CTCS-3 section should consider the insulation joint settings of track circuit.(8) This paper can provide references for the interface design of railway track layout and signaling.

Key words： Key words: railway')" href="#">

Key words: railway signal station interface design

	Service

	E-mail this article Key words: railway; signal; station; interface; design”. Please open it by linking:http://tdgcxb.crec.cn/EN/abstract/abstract144.shtml" name="neirong">
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	SHEN Zhi-ling

Cite this article:

SHEN Zhi-ling.

Research on the Interface Design of Railway Track-layout and Signal

[J]. 铁道工程, 2015, 32(2): 86-.

URL:

http://tdgcxb.crec.cn/EN/ OR http://tdgcxb.crec.cn/EN/Y2015/V32/I2/86

［1］TG/01—2014 ，铁路技术管理规程［S］.

TG/01—2014， Railway Technology Management Regulations［S］.

［2］TB 10621—2009，高速铁路设计规范（试行）［S］.

TB 10621—2009，Code for Design of High Speed Railway (Trial)［S］.

［3］TB 10007—2006，铁路信号设计规范［S］.

TB 10007—2006， Code for Design of Railway Signal［S］.

［4］GB 50091—2006，铁路车站及枢纽设计规范［S］.

GB 50091—2006，Code for Design of Railway Station and Terminal［S］.

［5］科技运［2010］136号，CTCS-2级列控系统应答器应用原则（V2.0）［S］.

The S&T Dept. and Transport Bureau of Ministry of Railways, PRC.［2010］136，The Application Principles of Balise in CTCS-2 Train Control System（V2.0）［S］.

［6］科技运［2010］21号，CTCS-3级列控系统应答器应用原则（V2.0）［S］.

The S&T Dept. and Transport Bureau of Ministry of Railways, PRC.［2010］21，The Application Principles of Balise in CTCS-3 Train Control System（V2.0）［S］.

［7］铁总运［2014］29号，CTCS-2级列控车载设备暂行技术规范［S］.

The Transport Bureau of China Railway Corporation［2014］29，The Provisional Technical Specification of the CTCS-2 On-board Equipment［S］.

［8］铁运［2012］83号，高速铁路无砟轨道线路维修规则（试行）［S］.

The Transport Bureau of Ministry of Railways, PRC.［2012］83，Maintenance Rules for Ballastless Track of High Speed Railway (Provisional Edition) ［S］.

［9］中铁第四勘察设计院集团有限公司. 客运专线铁路信号列控系统与铁路站场结合设计标准的研究［D］. 武汉：中铁第四勘察设计院集团有限公司，2010.

China Railway Siyuan Survey and Design Group Co. Ltd. The Research of Design Standard for Train Control System Combined with Railway Yard in Passenger Railway［D］. Wuhan:China Railway Siyuan Survey and Design Group Co. Ltd,2010.

［10］鄢巨平. 高速铁路站场几个相关问题的探讨［J］. 铁道工程学报，2002（2）：75-81.

Yan Juping. Several Related Issues in the High Speed Railway Station Yard［J］. Journal of Railway Engineering Society,2002(2)：75-81