|
|
|
| Functions for the Bearing Capacity of Lining Cross—section of Shield Tunnel |
| YUAN Yong，ZHAO Qing—li |
| Tongji University，Shanghai 200092，China |
|
|
|
|
Abstract Research purposes: The duct piece for shield tunnel lining is an eccentric pressed component with failure modes of the pressures on the big and small eccentric centers of the head—on cross—section and the shearing force on the oblique section．The functions expressed by moment of flexion or axial force for the bearing capacity of head—on Cross—section under typical condition were given in the previous study，but they can not fully attribute the working mode of the duct piece．This paper offers many expressions for the functions used for the bearing capacity of the pressures on the eccentric center of the head—on Cross—section and the shearing resistance of the oblique section based on the analytic formulas for the beating capacity and inner force of the duct piece for the shield tunnel lining in order to provide the reliability for calculating the bearing capacity of the cross—section，and evaluates the sensitive factors of the functions for the bearing capacity of the Cross—section of the duct piece．
Research conclusions: With establishing the functions for the bearing capacities of the head—on Cross—section and oblique section of the shield tunnel lining，the analytic formulas for the bearing capacity of head—on Cross—section with big and small eccentric center and shearing resistance of oblique section are offered．The sensitive analyses of the random variations of the functions for bearing capacity are made with an example．It is concluded for the bearing capacity of the head—on cross—section，the sensitivity of random variations is different when using the functions with different expressions，the Pv has the biggest influences on the functions for the bearing capacity of head—on Cross—section oil the arch top，and the f,has the biggest influence on the functions for bearing capacity of the oblique section on the arch web．
|
|
Received: 16 February 2009
|
|
|
|
|
|
[1] 陈慰如.偏心受压构件可靠度分析的极限状态方程[J]. 大连理工大学学报, 1991, 31(2): 193 -198.
[2] 焦涛.浅埋隧道衬砌设计及可靠度分析[D ].西安:西安科技大学, 2006.
[3] 谭忠盛,王梦恕.隧道衬砌结构可靠度分析的二次二阶矩法[J].岩石力学与工程学报, 2004, 23(13): 2243 -2247.
[4] 杨成永,张弥,白小亮.隧道喷混凝土衬砌结构可靠度分析的位移方法[J].岩石力学与工程学报, 2003, 22(2):266 -269.
[5] 胡志平.盾构隧道管片衬砌结构计算模型及稳定性风险分析研究[D ].上海:同济大学, 2004.
[6] GB 50010-2002,混凝土结构设计规范[S].
[7] DGJ 08-11-1999,地基基础设计规范[S].
[8] Working Group No. 2ITA. Guidelines for the design of shield tunnel lining[J]. Tunneling and Underground Space Tech- nology, 2000, 15(3): 303 -331.
[9] 刘宁.可靠度随机有限元法及其工程应用[M ].北京:中国水利水电出版社, 2001.
|
|
|
|
2009, Vol. 26 
